Contacts Over Ethernet - Model COE-8

COE-8 is a device for transmitting relay status and switch closure information over any IP network. The COE-8 system consists of an Input unit that collects up to 8 status points (wet DC voltage or dry contact closures) and an Output unit with eight relays. Upon any change of status of the inputs, a TCP message will be transmitted to the Output unit, which will change its relays to match the status of the inputs.

The COE-8 provides a link between older systems, which commonly use relay alarms, converting them into IP messages and re-converting them to relay closures at the other end of the network.

This cost-effective and easily implemented technology reduces the need for physical, on-site network management, administration and support by consolidating network equipment located in numerous remote locations into one central location. The COE-8 is an ideal solution for a variety of industries with critical communication needs including but not limited to broadcast, transportation, energy management, security and SCADA systems.

The COE-8 also supports a one-to-many delivery of switch closures. Up to 32 Output units can be simultaneously notified when an input state change is detected by the Input unit.

A Web browser interface is used for status monitoring and setup. Screw terminals are used to connect the inputs and the outputs. IP addressing is set either manually, by web browser or DHCP. TCP Port settable for both Web and control communication. Two level web security is provided for status monitoring and configuration. Two-level security allows different users for monitoring and setup.

For system developers, the control protocol for the COE-8 is available Contact Dataprobe Engineering. This allows you to integrate either the Input unit or Output unit into your own applications. Dataprobe also provides free a simple control program for operating the COE-8O. Click Here for the program.